📏 Size of each cup
Length 8 cm / 3.1 inches
Width 6.7 cm / 2.6 inches
Depth 0.7 cm / 0.27 inches
Material: Food Safe Silicone Rubber
This mold can be used for:
🔹 resin casting - Epoxy and Polyester
🔹 candy and chocolate making
🔹 candle making and wax melts
🔹 soap making or for adding little decorations to your soaps
🔹 clay modelling
🔹 fondant creations to design your cakes or cupcakes
🤚 Some vital info on the molds:
- The silicone meets the requirements of the BFR and FDA for food grade silicone
- Heat resistant up to a temperature of 200°C / 392°F and for short periods up to 250°C / 482°F. (Dough can be baked in the mold.)
- The mold is reusable
- Do not use a mold for crafts and then use it for food purposes due to contamination
- 🚫 Not suitable for UV resin
👉This mold was designed by myself and molded from a 3D printed design. So please keep in mind that the inside of the mold will not be completely smooth and will have some visible lines as can be seen from the photos. These lines are only visible to the eye and are smooth to the touch. If the mold is used for resin purposes, you can easily remove any visible lines from your resin piece by doming it.
Length 8 cm / 3.1 inches
Width 6.7 cm / 2.6 inches
Depth 0.7 cm / 0.27 inches
Material: Food Safe Silicone Rubber
This mold can be used for:
🔹 resin casting - Epoxy and Polyester
🔹 candy and chocolate making
🔹 candle making and wax melts
🔹 soap making or for adding little decorations to your soaps
🔹 clay modelling
🔹 fondant creations to design your cakes or cupcakes
🤚 Some vital info on the molds:
- The silicone meets the requirements of the BFR and FDA for food grade silicone
- Heat resistant up to a temperature of 200°C / 392°F and for short periods up to 250°C / 482°F. (Dough can be baked in the mold.)
- The mold is reusable
- Do not use a mold for crafts and then use it for food purposes due to contamination
- 🚫 Not suitable for UV resin
👉This mold was designed by myself and molded from a 3D printed design. So please keep in mind that the inside of the mold will not be completely smooth and will have some visible lines as can be seen from the photos. These lines are only visible to the eye and are smooth to the touch. If the mold is used for resin purposes, you can easily remove any visible lines from your resin piece by doming it.